MINNIDIP TIP // STEP 1

USING AN AIR PUMP

 

MINNIDIP TIP // STEP 1

USING A BLOW DRYER (MUST BE SET TO COOL)

 

MINNIDIP TIP // STEP 2

INFLATE WITH BREATH

 

!! IMPORTANT !!

CHECK YOUR VALVES

IF THERE IS A GAP BETWEEN THE BLACK PLUG AND OPEN PORT, AIR CAN SLOWLY LEAK OUT OVER TIME… ESPECIALLY THE TOP RING ONCE THE POOL IS FILLED WITH WATER AND THE BOTTOM TWO RINGS EXPAND IN DIAMETER. IF THE VALVE IS NOT CLOSED TIGHTLY PRIOR TO FILLING WITH WATER, IT CAN BECOME LOOSE ONCE WATER IS ADDED. IF YOUR TOP RING GOES FLAT, FILL WITH AIR AND MAKE CERTAIN THE VALVE IS PINCHED COMPLETELY SHUT PRIOR TO TUCKING IT INTO THE POOL.

Minnidip_valve1.png
Minnidip_valve2.png
Minnidip_valve3.png
 

!! IMPORTANT !!

INFLATION AND USE OF TUFTED COLLECTION

1. DO NOT OVER-INFLATE:

DO NOT ATTEMPT TO REMOVE ALL WRINKLES FROM THE POOL WALLS WHEN INFLATING. AIR AND VINYL EXPANDS IN THE HEAT AND IT WILL EXPAND ONCE IT WARMS UP IN HOT OUTDOOR TEMPS, ESPECIALLY ONCE FILLED WITH WATER. SO IF IT’S OVER-INFLATED, IT CAN STRAIN THE VERTICAL TUFTS, CAUSING THEM TO POP. NEVER USE AN AIR COMPRESSOR TO INFLATE, ONLY A STANDARD AIR PUMP.

2. ONLY PLACE ON LEVEL GROUND:

DO NOT SET UP YOUR TUFTED POOL ON ANY UNEVEN SURFACE AS WATER WILL PUSH TO ONE SIDE AS THE VINYL STRETCHES WHEN IT WARMS UP. IN HOT TEMPERATURES, THE VINYL WILL STRETCH, ESPECIALLY AS WATER WARMS UP. IF SET UP ON ANYTHING EXCEPT A COMPLETELY LEVEL SURFACE, WATER CAN PUSH ONE SIDE OF THE WALL CAUSING IT TO STRETCH AND WATER FLOW OVER.


DON’T HAVE YOUR MANUAL HANDY? NO PROBLEM!

DOWNLOAD THE MANUAL FOR THE 3-RING MANUAL